Fall alert
I want to build a fall alert on an Arduino Nano with an MPU6050 and a buzzer that sounds after a sudden fall.
Parts
Arduino Nano V3 (CH340, Type-C) In stock
MPU6050 3-Axis Gyro/Accel Sensor Module In stock
Active Piezo Buzzer Module 5V 2.3kHz In stock
Dupont Jumper Wire Kit (M-M, M-F, F-F, 20cm, 22AWG, ) In stock
USB Type-C to USB-A Cable (56kΩ pull-up, 1m, 22AWG) In stock
Pins, wiring and code
The pin table, the wiring steps and the code for this build are in Soldr. Start this build on Soldr - you can change it before you buy.