Glove that reads finger bends
I want to build a glove sensor on an Arduino Uno with a flex sensor that shows how far a finger is bent on a 0.96 inch OLED.
Parts
Arduino Uno R3 CH340G ATmega328P Board In stock
Spectra Flex Sensor 2.2 inch In stock
0.96 inch OLED Display Module 128x64 I2C Yellow/Blue (SSD1306) In stock
Resistor Variety Pack - , 10 Values, 1/4W Carbon Film In stock
23 AWG Solid Core Hookup Wire In stock
HC-SR04 Ultrasonic Sensor In stock
USB Type A to B Cable (1m) In stock
Pins, wiring and code
The pin table, the wiring steps and the code for this build are in Soldr. Start this build on Soldr - you can change it before you buy.