Dino jump game
I want to build an endless runner where a dinosaur jumps over cacti on an Arduino Uno with a 16x2 I2C LCD and one push button.
Parts
Arduino Uno R3 CH340G ATmega328P Board In stock- 16x2 I2C Character LCD Display Module (1602 + PCF8574, pre-soldered) In stock
Tactile Push Button Switch With Yellow Round Cap In stock
Male-to-Male Breadboard Jumper Wires (20 cm, 24 AWG) In stock
SYB-170 Mini Breadboard In stock
USB Type A to B Cable (1m) In stock
Pins, wiring and code
The pin table, the wiring steps and the code for this build are in Soldr. Start this build on Soldr - you can change it before you buy.