Dice roller
I want to build an electronic die on an Arduino Nano with an ADXL345 accelerometer and a 0.96 inch OLED that rolls when you shake it.
Parts
Arduino Nano V3 (CH340, Type-C) In stock
ADXL345 3-Axis Accelerometer Module In stock
0.96 inch OLED Display Module 128x64 I2C Yellow/Blue (SSD1306) In stock
23 AWG Multi-Strand Breadboard Wire In stock
USB Type-C to USB-A Cable (56kΩ pull-up, 1m, 22AWG) In stock
Pins, wiring and code
The pin table, the wiring steps and the code for this build are in Soldr. Start this build on Soldr - you can change it before you buy.